xTool SafetyPro AP2 Air Purifier Replacement Filters

DETAILS | RELATED ITEMS | FAQ

xTool SafetyPro™ AP2 Replacement Filters

Keep your xTool SafetyPro™ AP2 air purifier running at peak performance with genuine replacement filtration modules. These factory-spec filters restore airflow, maintain suction power, capture fine particles, and keep fumes and odors under control for laser cutters, engravers, DTF printing, apparel production, and workshop environments.

Replacement Filter Options

• Pre-Filter
  Captures hair, lint, fibers and large dust particles - protecting downstream filters and significantly extending total filter lifespan.
• Medium-Efficiency Filter
  Traps smaller particulates and PM dust to stabilize airflow before HEPA filtration and reduce premature clogging.
• Activated Carbon Filter
  Adsorbs fumes, chemical vapors, VOCs, and odors produced during laser processing, DTF powdering, curing, and printing.
• Dense Carbon Odor Layer
  High-capacity carbon matrix designed for heavy production environments where stronger odor control is required.
• High-Efficiency HEPA Filter
  Final filtration stage removes fine particulates down to 0.3µm - ensuring cleaner, safer exhaust air in indoor spaces.
• 5 Pack
  Save by purchasing a 5 pack of filters (includes 1 each Pre-Filter, Medium-Efficiency Filter, Activated Carbon Filter, Dense Carbon Odor Layer, High-Efficiency HEPA Filter)
  

Replace filters individually as needed. The AP2's multi-stage design means you only replace what's worn - reducing cost while keeping filtration performance strong.

Why Regular Replacement Matters

• Performance: Clogged filters reduce airflow, suction efficiency, and fume extraction capability.
• Safety: Clean filters maintain effective particulate capture and fume adsorption.
• Odor Control: Fresh carbon maintains VOC and odor absorption performance.
• Machine Protection: Keeps laser optics, electronics, films and workspace cleaner.

Typical lifespan varies by workload and environment. Under normal operation, most stages last between 100 - 600 hours. Monitor airflow and odor levels to determine replacement timing.

Installation - Quick & Simple

1. Power off the AP2 and unplug the unit.
2. Open the magnetic filter access door.
3. Remove the used filter stage and clean excess dust inside the chamber if needed.
4. Install the new filter in the correct order and direction.
5. Close the door, reconnect power, and briefly run the machine to seat the filter.

Clean the cyclone pre-stage regularly to maximize filter lifespan. Always follow the official operating guide.

Compatibility

These filters are engineered for the xTool SafetyPro™ AP2 air purifier, commonly used with xTool P2, S1, M1, D1, F1 and other CO2 and diode laser engravers and cutters, as well as for the xTool DTF Apparel Printer and any other DTF printing equipment setups, as well as screen printing, and fabrication environments to control smoke, fumes, dust, and odors.

Designed specifically for the xTool SafetyPro™ AP2 air purifier. (Not compatible with AP2 Max.)